Are you having broken garage door spring Grand Rapids that need immediate attention? It is prudent to call a professional to handle the repair for you. However, there are some people who have some knowledge on how to repair broken garage door spring Grand Rapids and may want to handle the task by themselves. One thing you need to understand is that these springs are heavy and long and are used in raising and lowering your garage door. There are some steps that you need to take care of in case you have broken garage door spring Grand Rapids. The most important thing is to make sure that the job is completed successfully. This task can be done with a lot of ease as long as you know what you are doing.
The first thing is to turn off the garage door power lest you risk being electrocuted while trying to make the repairs. Be keen to disconnect the power code of your garage door opener from the door. This mainly applies to new doors that are installed in your garage door because for the old versions, you will be expected to remove the fuse and then turn off the circuit break to disconnect the power.
Closely examine both the new and broken garage door spring Grand Rapids to ensure that they resemble one another. You have to ensure that they have the same dimensions and are of the same type. Avoid grabbing the new garage spring by the springs as you pick them up. You also have to take a marker or any other form of writing tool to mark the ends of the torsion shaft. This will make sure that you have level garage doors after removing the broken garage door spring Grand Rapids and replacing it with a new one.
Start by winding of the unbroken spring and unfastening the bolts while securing the spring bracket and torsion cones together before you can remove the bolts. After completing this step in the process of broken garage door spring Grand Rapids replacement, you can now re-install the spring and replace the hardware. You are now free to wind up the new springs after this step. Once you are done with this step, check and ensure that your garage door is balancing and is level. It is also good to apply some form of lubricant in order to minimize the friction.
Once you are sure that your door is balancing and all things are in their place and tight, you can now reconnect the garage door opener. You should have heard that you don’t need to play with the garage door and its opener but you need to shut and open it a few times to ensure that it is functioning properly. The process of fixing the broken garage door spring Grand Rapids is not a complicated one. The most important thing is to make sure that you are doing it carefully because the repair job can be dangerous if you don’t handle it carefully. I have seen people losing their fingers, limbs, hands, and even life because of not being careful.