The process of garage door opener installation Grand Rapids is normally a straightforward one. However, manufacturers and parts vary from one to another. Most of these openers are installed by the consumers and the installation instructions are quite clear. All parts are usually labelled to make sure that the installation process is simple. The process should be able to take a minimum amount of time and the opener will be functioning well.
Assembling the Opener
You need to lay out all the parts according to the instructions that are indicated by the manufacturer. Most of the parts contain labelled stickers while the others are stamped. The next step is to attach it to the motor head of the opener. after completely assembling the opener, the last step is the installation. Its good to leave the garage door opener installation Grand Rapids installation process to professionals especially if you are not sure of what is expected of you.
Attaching the Rail to the Header
To undertake this step, you will require a ladder that is 8-foot long. Raise the garage and then place a mark at the highest point. You can then close your garage door. Next, you can now measure up two inches from the site of the mark. Place there the header bracket bottom over the center of your garage door. Put the header bracket on the 2nd mark and use two wooden lag bolts to secure it. With the end of the monitor on the floor and the rail in the inner section of the header, line up the garage door opener assembly on the door. You will be required to line up the walls in the rail with the bracket header. Slide the clevis pin through the rail and bracket to attach.
Mounting the Motor
This is the last garage door opener installation Grand Rapids step. Place the ladder to the back of the garage door tracks, in the middle. You can now put the motor on the ladder. Raise your garage door slowly till it will get into contact with the door. As you continue opening the garage door, the motor assembly will continue to get lifted off the motor. Once the door fully opens, put a 2 by 4 between the garage door opener door and the rail.
For proper garage door opener installation Grand Rapids, you will be required to fasten the hangers to the head of the motor in the ceiling stuffs. Following the instructions and using the hangers that have been provided, you can use lag bolts to attach them to the ceiling. Once you attach the hangers, the next step is to lift the head of the motor and then bolt it to the ceiling hangers. At this point, your newly installed garage door opener will be ready for use. In case you are not sure of this process, don’t try it because you may cause harm to the opener or even harm yourself. You can reach us on www.CompleteGarageDoorMi.com/ or call now for professional assistance.