The garage door opener installation Grand Rapids MI is normally a straightforward one even though manufacturers and the specific parts tend to vary. It is important to follow the right steps so as to avoid exposing the garage doors to damage. In most cases, the sole responsibility of installing these garage doors is with the consumer and hence manufactures like to provide clear instructions of garage door opener installation Grand Rapids MI. Manufacturers normally label all the parts so as to make sure that you have an easy assembly process. You need to take a minimum amount of time on this process and the opener will be fully operational. In the meantime, click this link to learn more about us and the services we offer.
Assembling the Opener
Lay out all the parts according to the indication in the instructions. All the parts will always contain lettered stickers or are stamped. The initial step is normally the assembly of the rail. The next stage is to attach the rail to the motor head of the opener. After you have completely assembled the opener, the last thing to do is installing it. This process is normally standard irrespective of the model of the opener that you are dealing with. The most important thing is to check the specifics that are in each step.
Attach the Opener Rail to the Header
You need to have an eight-feet ladder to undertake this process. Raise the garage and mark its highest point before closing it. Measure up to two inches at the place where you have put the mark. You will place the bottom of the header at this point over the central part of the garage door. Place the bracket of the header at the second mark and use two wooden lag bolts to secure it. These precautions are very important in the garage door opener installation Grand Rapids MI process. Line up the assembly of the opener with the rail being inside the bracket of the header and the motor end on the floor. You will also be required to line up all the holes on the rail with the bracket of the header. The final move at this stage is sliding the clevis pin through the rail and bracket to attach. Undertake all these steps with a lot of keenness to avoid causing damage to the complete garage doors and ensure efficient functioning of the system. Mounting the Motor
This is the final step in the garage door opener installation Grand Rapids MI process. Put the ladder at the back of the garage door tracks but at the center. Raise the garage door slowly until it comes into contact with the door. As you continue opening the door, you will discover that the motor assembly will become lifted off the motor. Once the door gets opened fully, but a 2 by 4 between the door and the opener rail.
It is recommended to fasten the garage door hangers to the head of the motor in the ceiling stuffs so as to install the garage door opener properly. Using the provided hangers and instructions, use lag bolts to attach them to the ceiling. Once you attach the hangers, you will have to lift the head and then bolt it to the ceiling hangers. In case these instructions are not clear, feel free to call today for further assistance.